Your shopping cart is empty!
The Pull Stud is an unmistakably basic part of the machining process. Be that as it may, the fixing of the knob itself can prompt the toolholder not seating safely in the machine. You might lose tool life to knob tightness without knowing it.
Press Shops regularly give impressive consideration to only one end of a machining center’s toolholder—the end that holds the tool. On a tapered toolholder, the inverse end gets a Pull Stud. This Pull Stud is safe to say as close to imperceptible linchpin of the machining process. It is regularly overlooked.
The retention knob is not looked at as an element that was critical. A retention knob run out, and can be your first source of yak, poor tool life. With a rise in exotic stuff, higher feed speeds, and drawbar force, load forces being put on retention knobs have significantly raised. A typical misconception is that retention knobs tend not to wear out. Retention knobs used under normal 8 hour shifts should be inspected frequently and replaced. The retention knob is good for one year if the store is running 24 hours a day.
Toolengg' retention knobs are the greatest quality retention knobs in the marketplace. Our cut threads have radius screw thread points and are of UNJ set. Screw threads that are radius help raise the strength of the knob.
Now we produce over 400 distinct styles of custom fabrication knobs and retention knobs for exceptional scenarios.